You will need to install the device's anchor FIRST! The anchor is the part of the device that is glued to the toilet.
For best results, please watch the full video before beginning your UrinDx installation.
Determine Correct Position
Step 1
Dry the cleaned toilet area with a paper towel and then wipe down the area with the provided alcohol swab.
Step 2
To determine the correct position of your anchor, connect the UrinDx device to the anchor by sliding the top of the device up into the anchor overhang and then press the UrinDx device down towards the anchor to click in the lower tab.
Step 3
Hold the now connected anchor and UrinDx inside the toilet bowl keeping these factors in mind:
When looking down at your toilet bowl, UrinDx should be centered.
The anchor is downstream of flush holes and not covering them.
The angle of the device should slope down slightly.
AVOID the angle being too steep, causing the UrinDx to touch the water level.
AVOID UrinDx pointing up, preventing UrinDx from draining.
Place Anchor
Step 4
When confident in the location of the anchor, peel off the adhesive anchor backing. Place the anchor in the desired location and disconnect UrinDx from the anchor.
DO NOT get the adhesive wet as it will not remain sticky.
Step 5
Firmly press around the border and hold the center of the anchor against the toilet for 30 seconds.
Step 6
Do not touch the anchor or use the toilet for 45 minutes to ensure the anchor is adequately adhered to the toilet.
Step 7
After 45 minutes you may install the UrinDx device back onto the anchor.
Step 8
Device is now ready for use! 🙌
Once your anchor is successfully installed, please continue with the Daily Use instructions.
MAR-006 Ver 2, 11/03/2023
If you have questions about the Starling Medical app or UrinDx, please reach out to the Support Team via the blue bubble located on the bottom right hand side of your screen on the website, chat with us on the app, email us at [email protected], or call us at 800-343-5346.